Maury Microwave News

What's Happening at Maury

News & Press Releases

Press Releases, New Product Releases, New Literature, Announcements

Nano5G Automated Impedance Tuner

June 18 2021

Maury Microwave is pleased to announce the release of its Nano5G automated impedance tuner, optimized for maximum performance in 5G FR2 frequency bands.

The Nano5G has been designed to overcome the two main challenges related to on-wafer load pull measurements at 5G FR2 frequencies: reduced VSWR and phase skew at the probe-tip reference plane. The Nano5G has been miniaturized to less than 2.5” (less than 3.5” with integrated coupler) allowing it to be seamlessly connected to a wafer probe compatible with most commercial probe stations. The direct impact on load pull measurements at 28 GHz are clear: typical VSWR at the probe tip reference plane is increased from Γ = < 0.7 to Γ ≥ 0.87; typical phase skew is reduced from >200 degrees to < 30 degrees when considering a 100 MHz signal and two adjacent side channels.

More information regarding the Nano5G automated impedance tuner can be found here.

Data sheet 4T-050G10 can be downloaded here.






Past News

IVCAD 3.9 Release - July 7 2021
IQSTAR 1.2 Release - June 22 2021
IQSTAR 1.1 Release - July 15 2020
COVID-19 Update - March 24 2020
18 GHz 75ohm Type N cal kit - February 13 2020
IVCAD 3.8 Release - December 13 2018
High-Resolution Current Probes - January 26 2018
PNA B-Series Support - December 12 2017
Diplexers and Triplexers - November 19 2015
Expanded Measurement Services - October 28 2015
Low-Loss Couplers - May 25 2015
IVCAD Videos - PIV and STAN - February 20 2015
IVCAD Magic Source Pull - July 1 2014
High Speed Tuning - June 6 2014
MT1000 Product Launch - June 6 2014
IVCAD Video - June 5 2014
12 GHZ BNC cal kit - June 4 2014
LabVIEW Tuner Drivers - March 1 2014