Location:
In The Maury Training Center at Our Factory
Ontario, California USA
As part of Maury's after-sale customer service, two days of hands-on training is offered to customers who have purchased an Automated Tuner System (ATS). The training is held at Maury's Ontario, California factory, in the Maury Training Center. The Seminar objectives are to provide the ATS user with sufficient knowledge and insight to understand system thory and operation, to simplify installation and setup at the user's site, to minimize the learning period, and to expedite productive operation of the system. Class size is limited to approximately 10 persons per session (maximum) so each trainee receives individual attention and can ask as many questions as they desire.

Agenda (Day One):
• Orientation
• Introduction and Outline
• Measurement/System Overview
• Tuner Characteristics
• Software Orientation
• Program Familiarization
• Pre-measurement Requirements (Discussion)
• Device, Thru, and Tuner Characterization Demonstration
• Review and Discussion

Agenda (Day Two):
• Review
• Maury Plant Tour
• Live Measurements
• Live Measurements Review
• Writing Equipment Drivers/User Functions
• Review and Session Close

Study Materials:
Each trainee is provide with a copy of Maury's ATS Product Data Manual PB1003, which is a compilation of product data sheets, techinical journal article reprints and application notes pertaining to the ATS product line and the seminar subject matter. (Approximately 138 pages.)

Reservations are a Must!
To reserve your seat at an upcoming session of the ATS Users Training Seminar, contact the Maury Sales Department: